Screen 4-Logic

The Logic screen permits you to configure the form logic using rules, conditions and steps.

Rules are triggered by conditions and once triggered rules execute any steps that have been defined within them.

2019-12-17_2139.png

For a Rule you can:

  1. Define the Rule Name
  2. Mark as Active/Inactive
  3. Define the conditions check (1 condition must be met OR all conditions must be met)
  4. Define if the rule must be run once or not

 

For a Condition you can:

  1. Choose the type of condition
  2. Mark as Active/Inactive
  3. Once a condition is chosen the options shown will vary depending on the condition.

 

For a Step you can:

  1. Choose the type of step
  2. Mark as Active/Inactive
  3. Once a step is chosen the options shown will vary depending on the step.
Was this article helpful?
0 out of 0 found this helpful